What is the difference between a manufacturer’s defect and a design defect?

The difference between a manufacturer’s defect and a design defect lies in the cause of the product’s failure. A manufacturer’s defect is caused by a problem related to the manufacture or assembly of the product, such as a part that wasn’t properly installed or a faulty material used in construction. This type of defect is usually only found in one or a few products, as it is not an inherent flaw in the design of the product. A design defect, on the other hand, is one that originates from the product’s design. It affects any and all products that follow the same design, regardless of the manufacturer. These design flaws can be hard to detect, as they often depend on factors like the conditions in which the product is used and its intended purpose. They may also be caused by the product’s age or lack of testing. In Oklahoma, all product defects may be subject to the Dangerous Products Law. This law provides for the protection of consumers who are injured due to a product’s defective design or manufacture. This means that manufacturers are held liable for any injury or damage caused by their defective products, regardless of whether it was caused by a manufacturer’s defect or a design defect.

Related FAQs

What is an “implied warranty” defense to a product liability claim?
Who can be held liable in a product liability case?
What are the different types of product liability claims?
What is the Restatement Third of Torts?
What is a product liability lawsuit?
What are the requirements to prove a manufacturer is liable for an injury caused by a defective product?
What is an “open and obvious danger” defense to a product liability claim?
What is a “product misuse” defense to a product liability claim?
What is a defective product recall?
What is a “failure to repair” defense to a product liability claim?

What is the difference between a manufacturer’s defect and a design defect?

Related FAQs

Related Blog Posts